OFA Kam 6 Hybrid Owners Manual.fm Page 10 Wednesday, March 30, 2005 3:09 PM
OFA Kameleon™
NOTE: If the Inner IR segments did not blink twice, repeat steps 2 through 4 and try entering the same code again.
5.Aim the remote control at the device and press POWER once (or PLAY). It should turn off (or begin playing). If the device does not respond, repeat steps 2 through 5, trying each code for your brand until you find one that works. If it still does not work, try Searching For Your Code.
SEARCHING FOR YOUR CODE
If your device does not respond to the remote control after trying all codes listed for your brand, or if your brand is not listed at all, try searching for your code.
For example, to search for a code for your TV:
1.Turn on your TV and on the remote control, press TV once.
2.Press and hold SET until the two Inner IR segments flash twice. The current mode key will blink on and off during programming.
3.Enter 9 9 1. The Inner IR Segments will blink twice.
4.Select a test function from the list below or use the default test function (Power) and skip step 4
NOTE: Use any of the following keys for the
test function: 0, 1, 2, 3, Power, Volume Up, Play, Stop or Mute.
5.Press the ^ (Arrow Up) key to begin searching for your code. Stop the search when the device turns off or performs the function selected in step 4 (if other than Power).
NOTE: In the search mode, the remote control will send IR codes from its library to the selected device, starting with the most popular code first. Every press of the ^ (Arrow Up) key will send a new code. If you go past the code that performed the Test Function (selected in step 4), you can go back by pressing the v (Arrow Down) key.
6.To lock in the code, press and release the SET key. The Inner IR Segments blinks twice.
7.To search for the codes of your other devices, repeat steps 1 through 6, but substitute the appropriate device key for the device you are searching for, in step 1.
CHECKING THE CODES
If you have set up the remote control using the Searching For Your Code procedure, you may need to find out which
1.On the remote control, press TV once.
2.Press and hold SET until the two Inner IR segments flash twice. The current mode key will blink on and off during programming.
3.Enter 9 9 0. The Inner IR Segments will blink twice.
4.To view the code for the first digit, press 1 once. Wait 3 seconds, count the LED blinks (e.g., three blinks = 3) and write down the number.
NOTE: If a code digit is “0”, the LED will not blink.
