One for All URC-6690 owner manual Using Channel Scan, Clearing a Macro

OFA Kam 6 Hybrid Owners Manual.fm Page 12 Wednesday, March 30, 2005 3:09 PM

OFA Kameleon™ 6-Device Hybrid Remote

5.For the second device you want in the power-on sequence, press its device key (e.g., CBL/SAT) once.

6.For the third device you want in the power-on sequence, press its device key (e.g., AUD) once.

7.Repeat step 6 up to three more times to add the other desired devices to the power-on sequence (e.g., AUX,

VCR/PVR, etc.).

8.To save the settings and exit the program, press and hold SET until the Inner IR segments blink twice, then release SET.

TO OPERATE MASTER POWER MACRO

1.After programming, point the remote control at the devices and press POWER for at least 3 seconds to sequentially turn on (or off) your devices.

NOTE: When POWER is pressed for less than 3 seconds, a power command will only be sent to the currently-selected device. This allows you to still individually power devices on or off.

2.Devices will turn on (or off) according to your programmed sequence.

NOTE: The currently-selected device will always turn on or off first, followed by the remaining programmed sequence. After the master power sequence has been completed, the remote control will be set to control the first powered-on device.

NOTE: If one or more devices does not have a POWER key, the power off/on sequence may be slightly delayed when the remote control signals the device(s).This action is normal.

CLEARING A MACRO

1.Press and hold SET until the two Inner IR segments flash twice. The current mode key will blink on and off during programming.

2.Enter 9 9 5. The Inner IR Animation will blink twice.

3.Select a macro key (e.g., M1, POWER or any key programmed with a macro) you want to clear and press it once.

4.Press and hold SET until the two Inner IR segments flash twice, then release SET. The macro is now deleted but the keys (in the case of power), will retain their original function.

USING CHANNEL SCAN

In the TV, VCR/PVR, DVD and CBL/SAT modes, use the FAV key to start a 3-second scan of all favorite channels (if programmed, see Programming Favorite Channel Scan below) and/or all channels for the selected mode.

1.Press TV, VCR/PVR, DVD or CBL/SAT once.

2.Press FAV once.

•If Favorite Channel Scan has been set up, scanning of favorite channels will start and, upon completion, continue to scan all channels upward for the same device.

•If Favorite Channel Scan has not been set up, scanning will start with the current channel, then proceed to the next channel up, and continue until all channels of the selected device is scanned.

12 Using Channel Scan