![](/images/new-backgrounds/1313478/31347813x1.webp)
Setting up the ONE FOR ALL 2
Search method
The Search Method allows you to scan through all the codes contained in the memory of the ONE FOR ALL 2.
Example: To search for your television code:
1.
2.
3.
4.
5.
6.
7.
Switch your television on (not in standby).
Press the TV key on the ONE FOR ALL 2.
Press and hold down MAGIC until the ONE FOR ALL 2 red light blinks twice (the red light will blink once then twice).
Press 9 9 1. The red light will blink twice.
Next, press POWER.
Aim the ONE FOR ALL 2 at your Television. Now press
CH+ over and over, until your Television turns off
CH (every time you press the CH+ key the ONE FOR ALL 2 will send out a POWER signal from the next code contained in the memory). You may have to press this key many times (up to 150 times) so please be patient.
If you skip past a code, you can go to the previous code(s) by pressing the CH- key. Remember to keep pointing the ONE FOR ALL 2 at your Television while pressing this key.
As soon as your television turns off, press MAGIC to store the code.
-Most TV’s do not switch on pressing the POWER key. Please try pressing a “number” key or the
-If you cannot control your Television properly, please continue the Search Method, you may be using the wrong Code.
-To search for the code for another device follow the instructions above only press the appropriate device key instead of TV during step 2.
-If the original remote control of your DVD
WWW.ONEFORALL.COM | 7 |