NOTE: When you press POWER for less than 2 seconds, a power command will only be sent to the
2.Devices will turn on (or off) according to your programmed sequence.
NOTE: The
NOTE: If one or more devices does not have a POWER key, the power off/on sequence may be slightly delayed when the remote control signals the device(s).This action is normal.
Programming A Macro On A Device Key
In its default state, when you press a device key (e.g., TV) on this remote, the remote will switch to that selected device. However, you can also program a Macro onto the Device keys to allow for additional functionality. For example, if your devices are connected to a receiver unit, you can program a Device macro to switch the receiver’s input to the selected device.
To Program the Device Key Macro
For example, let’s assume that your DVD in connected to Input
3 of your receiver. You can program a macro that will switch the receiver’s input to input 3 when you press and hold the DVD key.
1.Press and hold SET until the LED (red light) blinks twice, then release SET.
2.Enter 9 9 5. The LED will blink twice.
3.Press the DVD key once.
4.Press the AUD key (to select the receiver).
5.Press digit 3 (for the input), and press DVD (to return control to the DVD key).
6.To save the settings and exit the program, press and hold SET until the LED blinks twice, then release SET.
NOTE: You can program up to 20 functions on the Device Key Macro. You can program a device Key Macro onto any device key.
To Operate the Device Key Macro
1.After programming, point the remote control at the receiver and press the DVD key for at least 2 seconds. This will switch the Receiver’s input to input 3, to allow you to view the DVD.
NOTE: When you press the device key (e.g., DVD) for less than 2 seconds, the remote will only select the DVD mode but will not change the Input on the receiver. This allows you to still change modes while using the remote.
NOTE: After executing the Device Key Macro, the remote will return to the DVD mode, to allow the control of the DVD device.
Clearing A Macro
1.Press and hold SET until the LED (red light) blinks twice, then release SET.
2.Enter 9 9 5. The LED will blink twice.
3.Select a macro key (e.g., M1, M2, M3 POWER or any device key) you want to clear and press it once.
4.Press and hold SET until the LED blinks twice, then release SET. The macro is now deleted but the keys (in the case of POWER and device keys), will retain their original function.
11
