One for All URC10820N warranty Using Channel Scan, Programming Favorite Channel Scan

Using Channel Scan

In the TV, VCR, DVD, CBL and SAT modes, use the FAV key to start a 3-second scan of all favorite channels (if programmed, “Programming Favorite Channel Scan”) and/or all channels for the selected mode.

1.Press TV, VCR, DVD, CBL or SAT once.

2.Press FAV once.

•If Favorite Channel Scan has been set up, scanning of favorite channels will start and cycle through stored channels, then proceed to the next channel up and cycle through all channels on the selected device.

•If Favorite Channel Scan has not been set up, scanning will start with the current channel, then proceed to the next channel up and cycle through all channels on the selected device.

3.To stop scanning channels at any time, press any key once.

Programming Favorite Channel Scan

In the TV, VCR, DVD, CBL and SAT modes, you can store a list of up to 10 favorite channels, in any order, that will be immediately scanned when you press FAV (see “Using Channel Scan”).

NOTE: Only channels of one mode can be stored for Favorite Channel Scan.

1.On the remote control, press TV, VCR, DVD, CBL or SAT once.

2.Press and hold SET until the LED (red light) blinks twice, then release SET.

3.Enter 9 9 6. The LED will blink twice.

4.Use the keypad to enter a favorite channel number (e.g., 031). Then press SET once.

NOTE: If the original remote control required pressing an ENTER key to change the channel, also press the ENTER key after the channel number (e.g., 0 3 1 ENTER).

5.If desired, repeat step 4 (in this section) for each favorite channel to be stored, up to a total of 10 channels.

NOTE: If you try entering more than 10 channels, the remote control will automatically exit programming.

6.To exit programming, press and hold SET for 3 seconds. The LED will blink twice.

Re-Assigning Device Keys

You can set this remote to control a second TV, VCR, DVD player, or other device. For example, to control a TV, a cable box, and two DVDs, you will need to re-assign the unused AUX1 key to operate the second DVD as follows:

1.On the remote control, press and hold SET until the LED (red light) blinks twice, then release SET.

2.Enter 9 9 2. The LED will blink twice.

3.Press DVD once, then press AUX1 once.

4.The AUX1 key is now ready to be programmed for your second DVD. See “Setting Up Your Components.”

To re-assign other device keys to the AUX1 key, repeat steps 1 through 4 by substituting the sequence from the following chart:

To Re-Assign Device	Perform Sequence
AUX1 as 2nd TV key:	SET - 9 - 9 - 2	- TV - AUX1
AUX1 as 2nd VCR key:	SET - 9 - 9 - 2	- VCR - AUX1

12