One for All URC10820N Using Keymover, Programming Keymover, Restoring a Single Keymoved Key

To Re-Assign Device	Perform Sequence
AUX1 as 2nd CBL key:	SET - 9 - 9 - 2 - CBL - AUX1
AUX1 as 2nd SAT key:	SET - 9 - 9 - 2 - SAT - AUX1
AUX1 as 2nd CD key:	SET - 9 - 9 - 2	- CD - AUX1
AUX1 as 2nd PVR key:	SET - 9 - 9 - 2	- PVR - AUX1
AUX1 as 2nd AUD key:	SET - 9 - 9 - 2	- AUD - AUX1
AUX1 as 2nd AUX2 key:	SET - 9 - 9 - 2	- AUX2 - AUX1

You can also re-assign another unused device key by substituting an open key for the AUX1 key in the above chart and performing the sequence. For example, to re-assign an unused CBL key as a 2nd CD key, perform SET - 9 - 9 - 2 - CD CBL. When a re-assignment is done, the LED (red light) will blink twice to confirm your choice. At that time, you will need to program the remote control for the new device (see “Setting Up Your Components”).

Using Keymover

This remote includes a Keymover feature that allows you to map (or copy) keys from one mode (i.e., source mode) to another mode (i.e., destination mode).

NOTE: The following keys cannot be used as a source or

destination: TV, CBL, SAT, VCR, DVD, CD, PVR, AUD, AUX1, AUX2, FAV, and SET.

Programming Keymover

For example, if your VCR does not have volume control, you can map those keys (i.e., VOL +, VOL -, and MUTE) from the TV mode to the VCR mode as follows:

1.Press and hold SET until the LED (red light) blinks twice, then release SET.

2.Enter 9 9 4. The LED will blink twice.

3.For the source mode, press TV once.

4.For the source key, press VOL + once.

5.For the destination mode, press VCR once.

6.For the destination key, press VOL + once.

7.The LED will blink twice, indicating the keymoved sequence is correct.

8.Repeat steps 1 through 7 twice more to map remaining volume control keys, substituting VOL - and MUTE as source and destination keys in steps 4 and 6.

Upon completion of the above procedure, you can now use this remote to control the TV’s volume and MUTE in the VCR mode, as well as in the TV mode.

Restoring Keymoved Keys To Default Settings

Restoring a Single Keymoved Key

1.Press a device key that has a keymoved key.

2.Press and hold SET until the LED (red light) blinks twice, then release SET.

3.Enter 9 9 4. The LED will blink twice.

4.Press the destination key twice (where the keymoved key is stored). The LED will blink twice.

13