One for All URC10820N Searching For Your Code, Checking the Codes

NOTE: If the LED did not blink twice, repeat steps 2 through 4

and enter the same code again.

5. Aim the remote control at the device and press POWER once.

It should turn off. If the device does not respond, repeat steps

2 through 4, trying each code for your brand until you ﬁnd

one that works. If it still does not work, try “Searching for Your

Code”.

Searching For Your Code

If your device does not respond to the remote control after trying

all codes listed for your brand, or if your brand is not listed at all,

try searching for your code. For example, to search for a code for

your TV:

1. Turn on your TV and on the remote control, press TV once.

2. Press and hold SET until the LED (red light) blinks twice, then

release SET.

3. Enter 9 9 1. The LED will blink twice.

4. Select a test function from the list below or use the default test

function (POWER) and skip step 4.

NOTE: The keys that can be used for the test function are 0, 1,

2, 3, POWER, VOL +, Play, Stop and MUTE.

5. Press CH+ to begin searching for your code. Stop the search

when the device turns off or performs the function selected in

step 4 (if other than POWER).

NOTE: In the search mode, the remote control will send IR

codes from its library to the selected device, starting with the

most popular code ﬁrst. Every press of CH+ will send a new

code. If you go past the code that performed the Test Function,

you can go back by pressing CH-.

6. To lock in the code, press and release the SET key. The LED

blinks twice.

7. To search for the codes of your other devices, repeat steps 1

through 6, but substitute the appropriate device key for the

device you are searching for in step 1.

Checking the Codes

If you have set up the remote control using the Searching For Your

Code procedure, you may need to ﬁnd out which four-digit code is

operating your equipment. For example, to ﬁnd out which code is

operating your TV:

1. On the remote control, press TV once.

2. Press and hold SET until the LED (red light) blinks twice, then

release SET.

3. Enter 9 9 0. The LED will blink twice.

4. To view the code for the ﬁrst digit, press 1 once. Wait 3

seconds, count the LED blinks (e.g., three blinks = 3) and write

down the number in the leftmost box in the TV code boxes.

NOTE: If a code digit is 0, the LED will not blink.

5. Repeat step 4 three more times for remaining digits. Use 2 for

the second digit, 3 for the third digit, and 4 for the fourth digit.

Write down the code digits in the remaining TV code boxes.

6. To check for codes of other devices, repeat steps 1 through

5, but substitute the appropriate device key for each device

you are checking. Write down the device’s code digits in the

appropriate code boxes.