First Time
5 | When the following display appears, | |
| ||
| move the speaker setup microphone to | |
| measurement point c (page 39), and | |
| then press [ENTER]. | |
|
|
|
|
|
|
Audyssey 2EQ™ performs more measurements.
This takes a few minutes.
When the measurements are complete, the results are calculated and saved automatically.
6 | When the room correction and speaker | ||
| |||
| setup is complete, disconnect the | ||
| speaker setup microphone. | ||
|
|
|
|
|
|
|
|
|
|
|
|
Note:
When the room correction and speaker setup is complete, “6. Equalizer” (page 72) will be set to “Audyssey.”
Error Messages
While the room correction and speaker setup is in progress, one of the following error messages may appear:
❏Ambient noise is too high
This message appears if there’s too much background noise and the measurements cannot be performed properly. Remove the source of the noise and try again.
❏Speaker Detect Errors
This message appears if one of the
•One of the front speakers has not been detected.
•One of the surround speakers has not been detected.
❏Write Error
This message appears if saving fails.
❏Mismatch Error
This message appears if a speaker that was detected during the 1st measurement is not detected during the 2nd or 3rd measurements. If this message appears, check your speaker connections, and then try again.
To Retry the Room Correction and Speaker Setup
Press the [ENTER] button.
Make sure speakers that cannot be detected are connected properly.
Changing the Speaker Settings Manually
If you wish to make changes to the settings found during the room correction and speaker setup, follow the directions on pages
Using a Powered Subwoofer
If you’re using a powered subwoofer, as it outputs very
41