Listening to SIRIUS Satellite
2 Use the Up and Down [q]/[w] buttons to select “9. Antenna Aim,” and then press [ENTER].
Note:
If the “SATRadio” is set to “None” (see page 53), the “Antenna Aim” item is not available.
3 | Adjust the position of the | ||
| |||
| indoor/outdoor antenna | ||
| connected to the SiriusConnect | ||
| receiver so that the satellite | ||
| (SAT) signal strength bar is as | ||
| long as possible. | ||
|
|
|
|
|
|
|
|
| If you cannot receive a satellite signal, | ||
| press the Down [w] button to display | ||
| the terrestrial (TER) signal strength | ||
| meter and adjust your antenna so that | ||
| the bar is as long as possible. | ||
| Terrestrial signals are only available in | ||
| certain areas. | ||
|
| ||
|
|
|
|
| So long as the signal strength is good, | ||
| you can enjoy SIRIUS Satellite Radio | ||
| by using either satellite or terrestrial | ||
| reception. | ||
|
|
|
|
Parental Lock
You can lock out channels that you do not want to receive.
1 | Press the [RECEIVER] button, |
| |
| followed by the [SETUP] button. |
2 Use the Up and Down [q]/[w] buttons to select “10. Parental Lock”, and then press [ENTER]. “Enter : <0>” appears on the display.
| Note: |
| If the “SATRadio” is set to “None” (see |
| page 53), the “ParentalLock” item is |
| not available. |
3 | Use the Left and Right [e]/[r] |
| buttons to change the number |
| displayed between the angle |
| brackets < >, and then press |
| [ENTER]. Repeat this for each |
| digit in the PIN number.* |
4 | Use the Up and Down [q]/[w] |
buttons to select the channel that you want to lock out, for example:
5 Press the Left and Right [e]/[r] buttons so that an asterisk appears next to the name, as shown below, and then press [ENTER].
The message “Locked” will appear on the display.
6 | Press the [SETUP] button. |
| |
| Setup closes. |
*The default number is “0000.” If you want to change the default setting, see “Changing the PIN Number” on page 59.
To unlock a previously locked channel, select the locked channel (see step
58