Onkyo 29344934 Advanced Setup—Continued, Unit, feet, meters, Notes, continue with this procedure

Advanced Setup—Continued

Unit	feet:	Distances can be set in feet. Range: 1 to 30 feet in 1-foot steps.
	meters:	Distances can be set in meters. Range: 0.3 to 9 meters in 0.3-meter steps.

Front, Center, SurrRight, SurrBack Right, SurrBack Left, SurrLeft, Subwoofer

Specify the distance from the each speaker to your listening position.

5. Level Cal (Speaker Levels Calibration)

These settings are set automatically by the Audyssey 2EQ™ Room Correction and Speaker Setup function (see page 39).

You can set the volume level of each speaker so that all speakers can be heard equally at the listening position. A pink noise test tone is output by the front left speaker.

Notes:

•Speakers that you set to “No” or “None” in the “3. Sp Config” (page 70) do not output the test tone.

•These settings cannot be changed while a pair of headphones is connected, or speaker set A is off, or speaker set B is on, or the AV receiver is muted.

Left, Center, Right, SurrRight, SurrBack Right, SurrBack Left, SurrLeft, Subwoofer

The levels can be adjusted from –12 to +12 dB in 1 dB steps (–15 to +12 dB for the subwoofer).

6. Equalizer (Equalizer Settings)

These settings are set automatically by the Audyssey 2EQ Room Correction and Speaker Setup function (see page 39). Here you can adjust the tone of individual speakers. To set the volume of individual speakers, see page 72.

Notes:

•You can select: “63Hz”, “250Hz”, “1000Hz”, “4000Hz”, or “16000Hz”. And for the subwoofer, “25Hz”, “40Hz”, “63Hz”, “100Hz”, or “160Hz”.

•While the Direct listening mode is selected, the equalizer settings have no effect.

•The equalizer setting cannot be changed while a pair of headphones is connected, or speaker set B is on.

EQ	Manual: You can adjust the equalizer for each speaker manually. If you select “Manual”,
		continue with this procedure.
		Select a frequency
		1	Use the Down [w] button to select “Ch”, and then use the Left and
			Right [e]/[r] buttons to select a speaker.
		2	Use the Up and Down [q]/[w] buttons to select a frequency. Use
			the Left and Right [e]/[r] buttons to adjust the level at that
			frequency.
			The volume at each frequency can be adjusted from –6 to +6 dB in 1 dB steps.
			Tip:
			Low frequencies (e.g., 63Hz) affect bass sounds; high frequencies (e.g.,
			16000Hz) affect treble sounds.
		3	Use the Up [q] button to select “Ch”, and then use the Left and
			Right [e]/[r] buttons to select another speaker.

Repeat steps 1 and 2 for each speaker.

Speakers that you set to “No” or “None” in the “3. Sp Config” (page 70) do not output the test tone.

Audyssey: The tone for each speaker is set automatically by the Audyssey 2EQ Room Correction and Speaker Setup function. Be sure to select this setting after having performed the Room Correction and Speaker Setup. “Dynamic EQ” and “Dyn Vol” become available (see page 74).

Off: Tone off, response flat (default).

72