Onkyo CR-445 iPod / iPhone Playback, Playing iPod / iPhone, 3To start playback, press the button

iPod / iPhone Playback

When you select iPod as the input source, the headphones output no sound. If use headphones, connect it directly to iPod.

Before using your iPod with the CD receiver, be sure to update your iPod with the latest software, available from the Apple Web site.

If you leave your iPod paused when using it on its own, eventually it will go into hibernation. If you insert it into the CD receiver dock in this state, you’ll need to wait a few moments before your iPod is ready for use.

Always remove your iPod before moving CD receiver.

Depending on your iPod, or the type of content being played, some functions may not work as expected.

Installing the iPod / iPhone Universal Dock Adapter

First, with the adapter slot facing the back, fit in the front of the adapter and then press in the back until a click is heard. To remove the adapter, lift the back side up. If the adapter is difficult to remove, insert a thin object into the slot and lift the adapter up.

Always use the Universal Dock Adapter enclosed with the iPod model to correctly set the iPod in the CD receiver.

Note:

The slot’s connection terminal could be damaged if the iPod is set in the CD receiver dock without using the Universal Dock Adapter.

Please purchase a commercially available dock adapter when using an iPhone or when the Universal Dock Adapter has been lost or damaged.

Make sure the slot is at the rear.

Playing iPod / iPhone

1Inserting your iPod into the CD receiver’s dock for iPod.

Raise the dock cover, insert your iPod ensuring that it is seated correctly.

Notes:

•The appropriate iPod universal dock adapter must be installed prior to inserting an iPod.

•To prevent damage to the dock connector, do not twist or force your iPod into the dock, and be careful not to wiggle your iPod while inserting it.

•Do not use with any iPod accessories, such as FM transmitters and microphones, as they may cause a malfunction.

•If you use your iPod with its case, always remove the case before you insert iPod. Otherwise, it will not connect properly and a malfunction may occur.

•Depending on the iPod / iPhone model or software version, it may take 30 seconds for the "Reading" process required for the connection to finish. If the connection is not established even after a minute, remove the iPod / iPhone from the unit once, and try setting it again.

2Use the INPUT [ ] / [ ] buttons to select “iPod”.

When no iPod is connected, “iPod No Device” will be displayed.

3To start playback, press the [ ] button.

Playback will begin.

To pause playback:

Press the [ ] button. The Pause indicator appears. To resume playback, press

the [ ] button again.

Notes:

•You can see the contents of “videos” and “photos” in your iPod on TV (see page 17). Confirm your iPod, if video output is available.

•The volume level is adjusted by using the VOLUME [ ] / [ ] knob or the buttons on the remote controller.

Adjusting the volume on your iPod has no effect. In case you inadvertently move your iPod volume control, make sure the volume level is not set too high before you reconnect your headphones.

27