Controlling other components connected to the DVD Receiver

The remote controller has two learning functions. One is entering the signal number for a remote controller of another brand that is pre-programmed. Another is a normal learning function that enables the remote controller to learn the codes from other remote controllers.

Caution

With some brand’s components, some buttons may not work correctly. In this case, program the command separately.

Learning a pre-programming code

 

 

By learning a pre-programming code, you can make the

 

 

5

Press the button that you

RC-484M remote controller able to operate a product from

programmed and check if the

another brand. The buttons that are used for operation are

 

 

given on the next page.

system operates correctly.

 

1

2

3

Find the 3-digit number for the brand name of the component that you want to operate in the table on the next page.

Turn on the component that you want to operate (i.e. DVD, satellite tuner, or television).

While holding down the MODE button on the RC-484M that you want to program, press the +10 button, and then release both buttons.

The SEND/LEARN indicator lights when the MODE button is pressed and turns off when the +10 button is pressed. Wait until the indicator turns off before releasing both buttons. Then the SEND/LEARN indicator lights again.

•If the component does not operate properly, return to step 3 and repeat the steps above.

•If it still does not operate properly, then program the commands one by one to the buttons on the RC-484M remote controller.

4

Within 30 seconds, enter the 3-digit
code number.

 

The SEND/LEARN indicator flashes twice

 

slowly. If the SEND/LEARN indicator

 

quickly flashes three times, then either a

 

mistaken 3-digit code was entered or an

 

incorrect operation was performed. If this

 

occurs, return to step 3.

78