Erasing the programmed command from one button

You can only erase memorized commands and not preset ones.

1

Press and hold down the desired
MODE button for the command,

 

press the ENTER button, and then

 

release both buttons.

 

When you press the MODE button, the

 

SEND/LEARN indicator lights. When you

 

press the ENTER button, the lamp turns

 

off. When you release the buttons, the

 

lamp lights again.

2

Press and release the button for the
command you wish to erase.

 

When you press the button, the SEND/

 

LEARN indicator turns off. When you

 

release the button, the lamp lights again.

3

Press and release the same button
again.

The SEND/LEARN indicator flashes twice slowly. The memorized command is erased.

Note

If no button is pressed for more than 30 seconds during the erasing procedure, the SEND/LEARN indicator flashes three times quickly, and the remote controller exits the erasing mode. Resume from Step 1.

SEND/LEARN indicator

MODE buttons

ENTER

Erasing all the commands programmed under a MODE button

1

Press and hold down the desired

MODE button, press the ENTER
button twice, and then release both buttons.

When you press the MODE button, the SEND/LEARN indicator lights. When you press the ENTER button, the lamp turns off. When you release the buttons, the lamp flashes twice slowly and then lights again.

2

Press and release the same MODE

 

 

button again.

 

When you release the button, the SEND/

 

LEARN indicator flashes twice slowly. This

 

erases all the commands memorized to the

 

MODE button.

 

 

Notes

If no button is pressed for more than 30 seconds during the erasing procedure, the SEND/LEARN indicator flashes three times quickly and the remote controller exits the erasing mode. Resume from Step 1.

If you perform an invalid operation during erasing, the SEND/ LEARN indicator flashes three times quickly, and the remote controller exits the erasing mode. Resume from Step 1.

If many commands have been programmed to the MODE button, then the SEND/LEARN indicator may remain lit for up to 20 seconds during Step 2. This is not a malfunction.

83