Onkyo HT-RC160 Getting to know Your Speaker Package—Continued, Attaching the Speaker Bases, En-8

Getting to know Your Speaker Package—Continued

Attaching the Speaker Bases

Before you connect the speakers, attach the supplied speaker base to each SKF-770.

1.Turn the speaker upside down with the protection cover attached.

2.Align the speaker base while the arrow mark is headed in the same direction as the speaker’s face. Be careful not to tip over the speaker.

3.Align the screw holes on the speaker base with those on the bottom of each speaker, and affix the speaker base using the supplied screws. Recommended torque is 10 kgf·cm (9 lbf·in).

Be careful not to tip over the speaker.

4.Turn the speaker right side up.

5.Remove the protection cover.

SAFETY PRECAUTIONS:

•Attach the speaker bases in a manner that will not allow the speakers to tip over.

•Be sure to tighten the screws when you attach the speaker bases.

•Attach the speaker bases on a flat, level, and stable floor.

•After you attach the speaker bases, make sure that the speakers stand upright and are stable.

Top of SKF-770

Protection cover

Supplied screws

Arrow mark

Speaker base

Bottom of SKF-770

En-8