Onkyo HT-RC160 Listening to the Radio, Using the Tuner, Tuning into Radio Stations

Listening to the Radio

Using the Tuner

With the built-in tuner you can enjoy AM and FM radio stations. You can store your favorite stations as presets for quick selection.

TUNING MODE

TUNER TUNING /

Listening to the Radio

Use the [TUNER] input selector button to select either AM or FM.

In this example, FM has been selected. Each time you press the [TUNER] but- ton, the input source changes between AM and FM.

Band Frequency

(Actual display depends on country.)

Tuning into Radio Stations

■Auto Tuning Mode

1Press the [TUNING MODE] but- ton so that the AUTO indicator

appears on the display.

2	Press the TUNING Up or Down
	[q]/[w] buttons.
	Searching stops when a station is
	found.

When tuned into a station, the TUNED indicator appears. When tuned into a stereo FM station, the FM STEREO indicator appears on the display, as shown.

FM STEREO

AUTO

TUNED

■ Manual Tuning Mode

1	Press the [TUNING MODE] but-
	ton so that the AUTO indicator
	disappears from the display.
2	Press and hold the TUNING Up or
	Down [q]/[w] buttons.
	The frequency stops changing when
	you release the button.
	Press the buttons repeatedly to change
	the frequency one step at a time.

This model changes FM/AM frequency in 200k/10k (or 50k/9k) Hz steps.

In Manual Tuning mode, FM stations will be in mono.

Tuning into weak FM stereo stations

If the signal from a stereo FM station is weak, it may be impossible to get good reception. In this case, switch to Manual Tuning mode and listen to the station in mono.

■Tuning into Stations by Frequency

You can tune into AM and FM stations directly by enter- ing the appropriate frequency.

1	Press the [TUNER] button repeat-
Remote	edly to select AM or FM, followed
	by the [D.TUN] button.
controller

(Actual display depends on country.)

2	Within 8 seconds, use the num-
	ber buttons to enter the fre-
	quency of the radio station.
	For example, to tune to 87.5 (FM),
	press 8, 7, 5.

53