Onkyo HT-RC160 Zone 2—Continued, Setting the Powered Zone, Not Act, The setup menu closes

Zone 2—Continued

Setting the Powered Zone 2

If you’ve connected your Zone 2 speakers to the AV receiver, as explained in “Connecting Your Zone 2 Speakers Directly to the AV receiver” on page 82, you must set the “Powered Zone 2” setting to “Act” (Acti- vated).

1	Press the [RECEIVER] button
	followed by the [SETUP] button.
	The main menu appears onscreen.
	If the main menu doesn’t appear, make
	sure the appropriate external input is
	selected on your TV.

2 Use the Up and Down [q]/[w] buttons to select “2. Speaker Setup”, and then press [ENTER]. The “Speaker Setup” menu appears.

2.Speaker Setup

1.Speaker Settings

2.Speaker Configuration

3.Speaker Distance

4.Level Calibration

5.Equalizer Settings

3 Use the Up and Down [q]/[w] buttons to select “1. Speaker Settings”, and then press [ENTER].

The “Speaker Settings” menu appears.

4	Use the Up and Down [q]/[w]
	buttons to select “Powered

Zone 2”, and use the Left and

Right [e]/[r] buttons to select:

Not Act:

ZONE 2 L/R speaker terminals not activated (Powered Zone 2 dis- abled).

Act:

ZONE 2 L/R speaker terminals activated (Powered Zone 2 enabled).

5	Press the [SETUP] button.
	The setup menu closes.

Notes:

•When “Act” is selected and Zone 2 turned on, the Zone 2 speakers connected to the ZONE 2 L/R speaker terminals output sound, but the surround back or front high speakers connected to the SURR BACK/ FRONT HIGH L/R speaker terminals do not. When “Act” is selected and Zone 2 turned off, the surround back or front high speakers output sound as normal.

•When the “Powered Zone 2” setting is set to “Act” and the input selector of Zone 2 is selected, power consumption on standby mode slightly increases.

•Powered Zone 2 cannot be used if “Speaker Type” is set to “Bi-Amp” (see page 42).

•This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

83