Onkyo HT-RC160 Speaker Settings, Powered Zone, The “Speaker Setup” menu appears, Front High

First Time Setup—Continued

Speaker Settings 4

If you change these settings, you must run the Audyssey 2EQ™ Room Correction and Speaker Setup again (see page 45).

If you’ve connected your front speakers to the FRONT L/R and SURR BACK L/R terminal posts for bi-amping, you must change the “Speaker Type” setting. For hookup information, see “Bi-amping the Front Speakers” on page 18.

Notes:

•When bi-amping is used, the AV receiver is able to drive up to 5.1 speakers in the main room.

• Before you change these settings, turn down the		5
volume.
1	Press the [RECEIVER] button,
	followed by the [SETUP] button.
	The main menu appears onscreen.
	If the main menu doesn’t appear, make
	sure the appropriate external input is
	selected on your TV.

2	Use the Up and Down [q]/[w] but-
	tons to select “2. Speaker
	Setup”, and then press [ENTER].
	The “Speaker Setup” menu appears.
		2. Speaker Setup
	1.	Speaker Settings	6
	2.	Speaker Configuration

3.Speaker Distance

4.Level Calibration

5.Equalizer Settings

Use the Up and Down [q]/[w] but- tons to select “Speaker Type”, and then use the Left and Right [e]/[r] buttons to select:

Normal: Select this if you’ve con- nected your front speakers normally.

Bi-Amp:Select this if you’ve con- nected your front speakers for bi-amped operation.

Note:

Powered Zone 2 cannot be used if “Speaker Type” is set to “Bi-Amp”.

Use the Up and Down [q]/[w] but- tons to select “Surr Back/Front High”, and then use the Left and Right [e]/[r] buttons to select:

Front High:

Select this if you’ve con- nected your front high speak- ers to the SURR BACK L/R terminal posts.

Surr Back:

Select this if you’ve con- nected your surround back speakers to the SURR BACK L/R terminal posts.

Note:

If the “Speaker Type” setting is set to “Bi-Amp”, or “Powered Zone 2” is set to “Not Act”, this setting cannot be selected.

Press the [SETUP] button.

The setup menu closes.

3	Use the Up and Down [q]/[w] but-
	tons to select “1. Speaker Set-
	tings”, and then press [ENTER].
	The “Speaker Settings” menu appears.
	2–1. Speaker Settings
	Speaker Type	Normal
	Powered Zone 2	Not Act
	Surr Back/Front High	Surr Back

Powered Zone 2

See “Zone 2” on page 82.

Note:

This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

42