Proxima ASA BNDL-001, PL-300E manual Fine-Tuning the Image, Status

Fine-Tuning the Image

LED	STATUS
Blinking Green	The link is intact, but there is no active input
	source selected on the transmitter.
Green	ProjectionLink is functioning correctly.
Blinking Green	The TV video signal is unstable. This will not
and Red	affect ProjectionLink’s image quality.

Fine-Tuning the Image

Depending on your Proxima projector, the length of CAT-5 cable used, or the type of computer signal being displayed, you may need to optimize the image quality by adjusting the gain and color settings on the receiver (PL-300R). We recom- mend you make these adjustments after you have all the cables and connections made at the transmitter and receiver. However, make these fine-tuning adjustments prior to install- ing the receiver in its final location.

There are two simple adjustments that will ensure the best possible image quality. The first of these is the gain adjust- ment. The gain control is located on the side of the receiver.

To make the gain adjustments, use the following steps:

1.Connect the CAT-5 cable to both the transmitter and receiver.

2.Connect a computer to ProjectionLink and display a test image. If you don’t have a test image go to www.Proxima.com to download one. Any white grid on a black background will work well.

3.Use a screwdriver or other small, narrow tool to turn the gain control on the side of the receiver to adjust the image. Adjust the dial clockwise for increasing cable lengths, and counterclockwise for decreasing cable lengths.

32 ProjectionLink User & Installation Guide