Onkyo HT-S6100 instruction manual Connecting Speaker Set A, Connecting Speaker Set B

Connecting Your Speakers—Continued

Connecting Speaker Set A

1	Strip 5/8" of insulation	5/8"
	from the ends of the
	speaker cables, and twist
	the bare wires tightly, as
	shown.

2 Unscrew the terminal. Fully insert the bare wire, making sure that it’s touching the threaded shaft in the center. Screw the terminal tight.

Connecting Speaker Set B

1	Strip 3/8" of insulation	3/8"
	from the ends of the
	speaker cables, and twist
	the bare wires tightly, as
	shown.
2 While pressing the lever, insert
	the wire into the hole, and then
	release the lever.
	Make sure that the terminals are
	gripping the bare wires, not the
	insulation.

Note:

While speaker set B is on, speaker set A is reduced to 5.1-channel playback.

The following illustration shows which speaker should be connected to each pair of terminals.

If you’re using only one surround back speaker, connect it to the left (L) SURR BACK SPEAKERS terminals.

	HDMI
	ASSIGNABLE
IN 3 (CBL/SAT)	IN 2 (VCR/DVR)	IN 1 (DVD)	OUT	SURR BACK SPEAKERS	SURR SPEAKERS	FRONT SPEAKERS A
ONENT VIDEO				L		L
Y		DOCK		AM
	(for DS-A1L)

		CB/ PB	CBL/SAT	VCR/DVR		DVD	MONITOR			CENTER SPEAKER
							OUT
			V					V	R	R
								ANTENNA
		CR/ PR						FM
			S					75
								S
N 1(DVD)	OUT		IN	OUT	IN	IN
SIGNABLE
IN	OUT	IN	IN	OUT	IN	FRONT	SURR	CENTER SURR BACK		PRE OUT
										L
										SUB
			L					L		WOOFER
			R					R		R
								SUB
CD		TAPE	CBL/SAT	VCR/DVR			DVD	WOOFER		FRONT SPEAKERS B

		Speaker Set A
Front right			Center	Front left
	speaker	speaker		speaker

SURR BACK SPEAKERS	SURR SPEAKERS	FRONT SPEAKERS A
L		L
		CENTER
		SPEAKER
R		R

Front right	Front left
speaker	speaker

Speaker Set B

Powered	Surround	Surround	Surround	Surround
subwoofer	back right	back left	right	left
	speaker	speaker	speaker	speaker

22