Onkyo HT-SP904 Connecting Components with HDMI, Connecting Your Components—Continued, Notes

Connecting Your Components—Continued

Connecting Components with HDMI

If you have an HDMI-compatible player, you can connect it to the AV receiver with an HDMI cable.

Step 1: Connect your HDMI-compatible TV to the AV receiver’s HDMI OUT jack.

Step 2: Connect your HDMI-compatible player to the AV receiver’s HDMI IN 1 or 2 jack.

Step 3: Connect your HDMI-compatible player to an analog and/or digital audio input on the AV receiver.

✽Audio and video signals received via the HDMI IN 1 and 2 jacks are output by the HDMI OUT jack as they are (HDMI pass-through), so even if you only make the connections in steps 1 and 2, your TV will output sound. However, if you want to listen through the speakers connected to the AV receiver, in addition to an

HDMI connection, you’ll also need to make a separate analog or digital audio connection.

Step 4: Assign the HDMI IN.

Turn on the AV receiver, and then assign the HDMI IN (see page 40)

	HDMI	HDMI
	OUT	IN
	Step 2	Step 1
DVD player	HDMI	HDMI
	ASSIGNABLE

Step 3 ✽

IN 1

	IN 2	IN 1	OUT	HDMI	ANTENNA
				ASSIGNABLE
				AM		FM 75
DIGITAL IN
ASSIGNABLE
COAX-
IAL1			Y
(DVD)								MONITOR
				CBL/SAT	VCR/DVR		DVD
								OUT	V
2			CB/PB	V
(CBL/SAT)
OPTICAL									S
1			CR/PR	S
(VCR/DVR)
	CBL/SAT IN VCR/DVR IN	DVD IN	OUT	IN	OUT	IN	IN
	COMPONENT VIDEO
2
	IN	OUT	IN	IN	OUT	IN	FRONT	SURROUND CENTER
(CD)
	L		L	L					L
	R		R	R					R
REMOTE									SUB
CONTROL	CD	TAPE		CBL/SAT	VCR/DVR			DVD	WOOFER

Connect one or the other

TV

Tip!

If you make the connection described in step 3, to fully enjoy the AV receiver's lis- tening modes, turn down the volume on your TV all the way so that its speakers output no sound.

Sound off

Notes:

•Audio and video signals received via the HDMI IN jacks are output only by the HDMI OUT.

•Audio and video signals received via inputs other than the HDMI IN jacks are not output by the HDMI OUT.

•The HDMI video stream is compatible with DVI (Digital Visual Interface), so TVs and displays with a DVI input can be connected by using an HDMI-to-DVI adapter cable. (Note that DVI connections only carry video, so you’ll need to make a separate connection for audio.) However, reliable operation with such an adapter is not guaranteed. In addition, video signals from a PC are not supported.

•To watch an HDMI source that’s connected via the AV receiver’s HDMI jacks, the AV receiver must be turned on, otherwise no HDMI signal will be output.

•The HDMI audio signal (sampling rate, bit length, etc.) may be restricted by the connected source component. If the picture is poor or there’s no sound from a component connected via HDMI, check its setup. Refer to the connected component’s instruction manual for details.

28