Connecting Your
Center Speaker Base
Use the center speaker base to mount the center speaker horizontally. If you place the speaker and its base on top of a TV or an entertainment center, adjust the angle of the speaker so that it faces toward the listening position. The center speaker should be installed on the base securely. If the speaker is loose, try adjusting the position so that it sits securely on the base.
The cradle surface of the base features two stoppers to prevent the speaker from moving. Therefore, you can tilt the speaker toward the front by up to 11 degrees.
11
Stoppers
Base for horizontal mounting
■Using the included rubber spacers
We recommend using the supplied rubber spacers to achieve the best possible sound from your speakers. The rubber spacers prevent the speakers from moving, providing a more stable setup.
Rubber spacer
Front
Bottom of the bass
Wall Mounting
The speakers can easily be wall mounted by using the keyhole slots. To prevent the speaker from vibrating against the wall, attach four of the supplied rubber spac- ers to the rear of each speaker.
■Mounting vertically
To mount the speakers vertically, use the one keyhole slot shown to hang each speaker on the screw that is securely screwed into the wall.
Rubber spacer
Keyhole slot for wall mounting
■Mounting horizontally
To mount the speakers horizontally, use the two keyhole slots shown to hang each speaker on two screws that are securely screwed into the wall.
Keyhole slot for wall mounting
Rubber spacer
The plaque of each speaker rotates so that you can posi- tion the speakers upside down.
Caution:
A mounting screw’s ability to support a speaker depends on how well it’s anchored to the wall. If you have hollow walls, screw each mounting screw into a stud. If there are no studs, or the walls are solid, use suitable wall anchors. Use screws with a head diameter of 3/8" or less and a
shank diameter of 1/8" or less. With hollow walls, use a | ||
cable/pipe detector to check for any power cables or | ||
water pipes before making any holes. | ||
Leave a gap of between 1/4" | Wall | |
and 5/16" between the wall and | ||
| ||
the base of the screw head, as |
| |
shown. |
| |
(We recommend that you con- |
| |
sult a home installation profes- |
| |
sional.) | 1/4" – 5/16" | |
| ||
20
