Onkyo HT-SP904 instruction manual Digital Input Signal Formats, Correcting Sound and Picture Sync

Advanced Setup—Continued

Digital Input Signal Formats

The following table shows the display indicator for each digital signal format.

Format	Display
Dolby Digital
DTS
PCM		PCM

Normally, the AV receiver detects the signal format auto- matically. However, if you experience either of the fol- lowing issues when playing PCM or DTS material, you can specify the signal format as either PCM or DTS:

•If the beginnings of tracks from a PCM source are cut off, try the PCM setting.

•If noise is produced when fast forwarding or reversing a DTS CD, try the DTS setting.

MASTER VOLUME

STANDBY/ON

TUNING

PRESET

STANDBY

MULTI CH

DVD

VCR/DVR

CBL/SAT

AUX

TAPE

TUNER

C D

SETUP

ENTER

RETURN

AUX INPUT

PHONES

SETUP MIC

VIDEO

L AUDIO

R

DISPLAY DIGITAL INPUT

TONE

STEREO

LISTENING MODE

DIMMER

MEMORY TUNING MODE

DIGITAL INPUT

1		Press and hold the AV receiver’s
	DIGITAL INPUT	[DIGITAL INPUT] button for about
		3 seconds.
2		While “Auto” is displayed (about
	DIGITAL INPUT	3 seconds), press the [DIGITAL
		INPUT] button repeatedly to
		select: PCM, DTS, or Auto.

PCM: Only PCM format input sig- nals will be heard. If the input signal is not PCM, the PCM indicator will flash and there will be no sound.

DTS: Only DTS format input sig- nals will be heard. If the input signal is not DTS, the DTS indicator will flash and there will be no sound.

Auto (default): The format is detected automatically. If no digital input signal is present, the corresponding analog input is used instead.

Correcting Sound and Picture Sync

When using progressive scanning on your DVD player, you may find that the picture and sound are out of sync. With this setting, you can correct this by delaying the audio signals. You can set it from 0 to 100 milliseconds (ms) in 20 millisecond steps.

	STANDBY/ON		REMOTE MODE		RECEIVER
			RECEIVER	DVD
		TAPE/AMP
	INPUT SELECTOR			M D/CDR
INPUT	1	2	3	CD
				DOCK
	VCR/DVR	CBL/SAT
SELECTOR	4	5	6	T V
	AUX	MULTI CH	DVD
	7	8	9	VCR
	TAPE	TUNER	CD	CABLE
	10	11	12
	+10	0	CLR	SAT
	D TUN	ENT
	--/---	DIMMER	SLEEP
	TV	VOL	CH	VOL
			DISC
			ALBUM
	INPUT
	GUIDE		PREVIOUS
	TOP MENU			MENU
	SP A / B			MUTING
		ENTER
	PLAYLIST/CAT		PLAYLIST/CAT
	SETUP			RETURN

1	Press the [RECEIVER] REMOTE
RECEIVER	MODE button.

2		Press and hold, for more than 4
1	2	seconds, the input selector but-
		ton for the input source that you
VCR/DVR CBL/SAT
4		6 want to correct.
AUX		DVD
		This can be the [DVD], [VCR/DVR],
		[CBL/SAT], or [AUX] input source.
3		Use the Left and Right [ ]/[ ]

buttons to adjust the delay from 0 to 100 milliseconds in 20 milli- second steps.

Note:

•This setting is not available when the Direct listening mode is used with an analog input signal.

62