Recording (continued)
MINIDISC RECORDER
| EDIT/ NO YES | MULTI JOG | |
|
| ||
| DISC LOADIING MECHANISM |
|
|
| CD | REC |
|
INPUT | REC MODE DUBBING | PUSH TO ENTER | |
REC
STANDBY / ON
STANDBY
DISPLAY
button and then start playing the recording source immediately.The TOC indicator appears as recording starts.
The MD recorder will automatically stop when recordable time on the disc expires. The tracks are automatically numbered. (Level Sync function)
TRACK
L
| 40 | 10 | 6 | 2 | 0 |
TOC | R |
|
|
|
|
Since the interval between tracks is detected based on the sound level, some tracks may not be numbered correctly in the following cases:
•The recorded condition of the cassette tape is bad (noise between tracks).
•There is a low sound level in quiet music.
•The interval between tracks is extremely short.
•The tuner's reception is poor (noisy).
To disable the Level Sync function, refer to
“Using the Level Sync function” on page 29.
While recording, press the 
REC button when you wish to mark a track number.
If you wish to mark two or more track numbers sequentially, provide a sufficient interval between each press of the 
REC button. Too short an interval (about 4 seconds or less) may lead to a failure in marking track numbers.
Press the 
button (or the 
button on the remote controller). To resume recording, press
the 
button (or press the 
button on the remote controller).
Press the 
STOP button.
Press the 
STOP button, then the 
EJECT button.
The track number and other information is written in the MD’s TOC (Table of Contents) area when the MD recorder ejects the disc, enters
Do not disconnect the power cable or move the unit under the following circumstances. Otherwise, the information will not be written correctly.
•The TOC indicator is lit.The information to be written into the MD’s TOC area is currently stored in the recorder’s memory.
•The TOC indicator is flashing.The recorder is now writing the information in the MD’s TOC area.
26