Onkyo PHC-5 instruction manual Checking the programmed functions, Erasing all programmed functions

Checking the programmed functions

Check to see if the programmed buttons operate the corresponding device correctly. If pressing one of the programmed buttons does not cause the SENDING/LEARNED indicator on the remote controller to light up, re-program again.

Press one of the programmable button to operate the corresponding device.

POWER

		VIDEO CONTROL
TV/VCR
POWER
		TV CONTROL
TV/VIDEO	VOLUME	CH

If the device does not respond correctly, refer to page 15.

If the programmed buttons do not enable you to operate the device correctly, review the following:

•The remote controller does not work unless it is close to the device, or the device has a slow response to remote con- troller operation.

The remote controller signal may not be programmed properly. Re-program the signal again. If the problem persists, check to see if the battery voltage is low.

•The programmed signal has been erased.

The programmed remote controller signals will be erased if the batteries have been removed for more than 30 minutes. You need to re-program the signals.

Erasing all programmed functions

1 Press the LEARN button.

LEARN

Perform the next step within fifteen seconds.

2 Press and hold the POWER button and press the VOLUME † button.

POWER

VOLUME

Hold down both buttons until the SENDING/LEARNED indicator turns off. All programmed functions will be erased.

17