66
First Time Setup—Continued
The speaker type detected does not match what was
expected. The speaker may be incorrect type or bro-
ken. Please check that it is the correct speaker type.
❏Speaker Matching Error!
The number of speakers detected on the second mea-
surement and later was different to the number
detected on the first measurement.
Make sure speakers that could not be detected are
connected properly.
Retry: Return to step 2 and try again.
Cancel: Cancel the room correction and speaker setup.
❏Writing Error!
This message appears if saving fails.
Try saving again. If this message appears after 2 or 3
attempts, the AV receiver is probably malfunctioning.
Contact your Onkyo dealer.
Retry: Return to step 2 and try again.
Cancel: Cancel the room correction and speaker setup.

Changing the Speaker Settings Manually

If you wish to make changes to the settings found during
the room correction and speaker setup, follow the
directions on pages 95 to 98.
Notes:
• Please note that THX recommends any THX main
speakers be set to “80Hz(THX)”. If you set up your
speakers using Audyssey MultEQ XT Room
Correction and Speaker Setup, please make sure
manually that any THX speakers are set to 80 Hz
(THX) crossover (see page 95).
• Sometimes due to the electrical complexities of
subwoofers and the interaction with the room, THX
recommends setting the level and the distance of the
subwoofer manually.
• Sometimes due to interaction with the room, you may
notice irregular results when setting the level and/or
distance of the main speakers. If this happens, THX
recommends setting them manually.

Using Powered Subwoofers

If you’re using powered subwoofers that output very
low-frequency sound at a low volume level, it may not be
detected by Audyssey MultEQ® XT Room Correction
and Speaker Setup.
If the “Subwoofer” appears on the “Review SP
Configuration” screen as “No”, increase the subwoofer’s
volume to the half-way point, set it to its highest
crossover frequency, and then try running
Audyssey MultEQ XT Room Correction and Speaker
Setup again. Note that if the volume is set too high and
the sound distorts, detection issues may occur, so use an
appropriate volume level. If the subwoofer has a low-
pass filter switch, set it to Off or Direct. Refer to your
subwoofer’s instruction manual for details.
FL : Error
SL : Yes
FWL : ---
FHL : ---
SBL : Yes
C : Yes
FR : Yes
SR : Yes
FWR : ---
FHR : ---
SBR : Yes
SW1 : Yes
SW2 : Yes
MultEQ XT: Auto Setup
Retry
Cancel
Speaker Detect Error
MultEQ XT: Auto Setup
Retry
Cancel
Speaker Matching Error!
MultEQ XT: Auto Setup
Retry
Cancel
Writing Error!