127
NET/USB—Continued
Mac Address
This is the AV receiver’s MAC (Media Access Control)
address. This address cannot be changed.
DHCP
This setting determines whether or not the AV receiver
uses DHCP to automatically configure its IP Address,
Subnet Mask, Gateway, and DNS Server settings.
Enable: DHCP enabled.
Disable: DHCP disabled.
If you select “Disable”, you must configure the “IP
Address”, “Subnet Mask”, “Gateway”, and “DNS
Server” settings yourself.
IP Address
If you set the “DHCP” setting to “Disable”, you must
specify an IP address. Enter a static IP address provided
by your ISP.
The IP address must be within the following ranges.
Class A: 10.0.0.0 to 10.255.255.255
Class B: 172.16.0.0 to 172.31.255.255
Class C: 192.168.0.0 to 192.168.255.255
Most routers use Class C IP addresses.
Subnet Mask
If you set the “DHCP” setting to “Disable”, you must
specify a subnet mask address.
Enter the subnet mask address provided by your ISP
(typically: 255.255.255.0).
Gateway
If you set the “DHCP” setting to “Disable”, you must
specify a gateway address.
Enter the gateway address provided by your ISP.
DNS Server
If you set the “DHCP” setting to “Disable”, you must
specify a DNS server.
Enter the DNS server addresses provided by your ISP.
Proxy URL
To use a Web proxy, enter its URL here.
Proxy Port
If you’re using a Web proxy, enter a proxy port number
here.
Control
This setting enables or disables control over the network.
Enable: Control over the network enabled.
Disable: Control over the network disabled.
Note:
When set to “Enable”, power consumption on standby
mode slightly increases.
■Port Number
This is the network port used for control over the net-
work.
Note:
Set the port number between from “49152” to “65535”.
USB can be used to play music files stored on USB mass
storage devices (e.g., USB flash drives and MP3 play-
ers), which can be plugged into the AV receiver’s USB
port.
Supported Audio File Formats
For USB mass storage device playback, the AV receiver
supports music file formats.
See “Supported Audio File Formats” on page 124.
USB Mass Storage Device Requirements
• The AV receiver supports USB devices that support
the USB mass storage device class.
• Playback may not be possible with some USB devices
even if they conform to the USB mass storage device
class.
• USB devices formatted with the FAT16 or FAT32 file
system are supported.
• If the storage device has been partitioned, each section
will be treated as an independent device.
• Each folder may contain up to 20000 music files and
folders, and folders may be nested up to 16 levels
deep.
• USB hubs and USB devices with hub functions are not
supported.