53
First Time Setup—Continued
Notes:
See page 32 for charts showing how the “Monitor
Out” and “Resolution” settings affect the video signal
flow through the AV receiver.
This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
5Use the Up and Down [ ]/[ ] but-
tons to select “Resolution”, and
use the Left and Right [ ]/[ ]
buttons to select:
Through:
Select this to pass video through the
AV receiver at the same resolution
and with no conversion.
Auto :
Select this to have the AV receiver
automatically convert video at reso-
lutions not supported by your TV.
480p (480p/576p):
Select this for 480p or 576p output
and video conversion as necessary.
720p:
Select this for 720p output and
video conversion as necessary.
1080i:
Select this for 1080i output and
video conversion as necessary.
1080p :
Select this for 1080p output and
video conversion as necessary.
1080p/24 :
Select this for 1080p output at 24
frames per second and video con-
version as necessary.
Source:
Output will be according to the res-
olution level which was set in the
“Picture Adjust” setting (see
page 105).
Tips:
The “Resolution” setting can also be
set using the [VIDEO] button on the
remote controller.
The “Resolution” setting is set
respectively of main, sub, and
analog.
Notes:
Settings marked with an asterisk ( )
are not available when the “Monitor
Out” setting is set to “Analog”.
If the “Monitor Out” setting is set to
“Both”, this setting is fixed at
“Auto”.
Depending on the incoming video
signal, video playback may not be
smooth or the vertical resolution may
be lowered. In this case select other
than “1080p/24”.
*
*
*
*
6Press the [SETUP] button.
The setup menu closes.