87
Using the Listening Modes—Continued

5.1 channel Sources (3/3)

: Available Listening Modes
Notes:
*1 For 7ch output, output can be switched between Front high or Front wide speakers by pressing the [SP LAYOUT] button (depending on the
“Speaker Configuration” setting (see page 95)).
*2 For 9ch output, output can be switched between the combination of Surround back and Front high, or Surround back and Front wide
speakers by pressing the [SP LAYOUT] button.
*3 AV receiver can input the DSD signal from HDMI IN. Setting the output setting on the player side to PCM might obtain a better sound
according to the player. In that case, set the output setting on the player side to PCM.
*4 This listening mode can be selected only when all the following conditions are satisfied:
a. Center speaker is connected to the AV receiver.
b. Either of Front High speakers or Front Wide speakers is connected to the AV receiver.
Output can be switched between Front high or Front wide speakers by pressing the [SP LAYOUT] button (depending on the “Speaker
Configuration” setting (see page 95)).
*5 This listening mode is not available while you are using Zone 2 (“Not Available” will appear on the display). If you turn Zone 2 on during
the Pure Audio listening mode, the listening mode will change to Direct.
*6 Depending on the input source, DTS is used.
Available sampling rate for PCM input signal is 32/44.1/48/88.2/96/176.4/192kHz.
The listening modes cannot be selected with some source formats.

Listening Mode Button

Speaker layout

T-D (Theater-

Dimensional) ✔✔✔✔

DTS Surround

Sensation ✔✔✔✔

LH RH
SBRSBL
FL FR
LW RW
C
SL SR
SW SW
LH RH
SBRSBL
FL FR
LW RW
C
SL SR
SW SW
LH RH
SBRSBL
FL FR
LW RW
C
SL SR
SW SW
LH RH
SBRSBL
FL FR
LW RW
C
SL SR
SW
*1 *1
*2*2
*1 *1 *2*2
*2 *2
SW