Onkyo TX-NR515 instruction manual En-22, Source Connection, Remote Mode Setup, Network Connection

Source Connection

This step checks the connection of source components.

1 Use q/wto select one of the following options, and then press ENTER.

`Yes, Continue: Performs the checkings.

`No, Skip:

Skips this step and continues to “Remote Mode Setup”.

2 Select the input selector for which you want to check the connection and press ENTER.

The picture of the corresponding source should appear on screen with a verification prompt.

3 When prompted, use q/wto select one of the following options and then press ENTER.

`Yes:

Confirms that the source is properly displayed. `No:

Displays an error report. Follow the troubleshooting instructions and recheck the source.

4 Use q/wto select one of the following options, and then press ENTER.

`Yes:

Returns to step 2.

`No, Done Checking:

The setup wizard continues to “Remote Mode

Setup”.

Remote Mode Setup

With this step, you can enter remote control codes for the components you want to operate.

1 Use q/wto select one of the following options, and then press ENTER.

`Yes:

Performs the remote control code input. Refer to step 5 of “Looking up for Remote Control Codes” (➔ page 70).

`No, Skip:

Skips this step and continues to “Network

Connection”.

2 When you’re finished, select one of the following options and press ENTER.

`Yes, Done:

The setup wizard continues to “Network

Connection”.

`No, not yet:

You can enter other remote control codes.

Turning On & Basic Operations

Network Connection

This step checks your network connection.

1 Use q/wto select one of the following options, and then press ENTER.

`Yes:

Performs the checkings.

`No, Skip:

Skips this step and terminates the initial setup.

Note

•If you use both wired and wireless network connections, the wireless will take priority.

For further details, see the instruction manual provided with your wireless device.

2 Follow the instructions on screen to perform the network checking.

The checking is complete when the message

“Successfully connected.” appears at the middle of the screen. Press ENTER to terminate the initial setup.

3 If an error message appears, select one of the following options and press ENTER.

`Retry:

Performs the checking again. `No, Do it Later:

Skips this step and terminates the initial setup. The setup wizard goes to “Terminating the Initial Setup”.

Terminating the Initial Setup

This step ends the initial setup process.

1 Press ENTER.

To restart the initial setup, select “Initial Setup” in the “Hardware Setup” menu (➔ page 64).

En-22