
First Time
6 Use the Down [ ] button to select “Surround,” and then use
ENTER
the Left and Right [ ]/[
] but- tons to select Small, Large, or
None.
Small: Select if the surround speak- ers are small.
Large: Select if the surround speak-
ENTER
ers are large.
None: Select if no surround speakers are connected.
Note:
•If the Front setting in step 4 is set to Small, the Large option cannot be selected.
Testing the Speakers
To make sure that all of the speakers are working
properly, press the remote controller’s [TEST
TONE] button. A test tone will be output by each speaker in turn and the name of each speaker will appear on the display. To turn off the test tone, press the [TEST TONE] button again.
•If the test tone is not produced by a speaker, or it’s produced by a speaker other than the one shown on the display, you may have wired it incorrectly and should check your connections (see page 17).
•If the test tone is not produced by a speaker, and its name does not appear on the display, check the speaker configuration (see page 32).
7
ENTER
ENTER
Use the Down [ | ] button to |
select “Surr Back,” and use the | |
Left and Right [ | ]/[ ] buttons to |
select Small, Large, or None.
Small: Select if the surround back speakers are small.
Large: Select if the surround back
speakers are large.
None: Select if no surround back speakers are connected.
Notes:
•If the Surround setting in step 6 is set to None, this setting does not appear.
•If the Surround setting in step 6 is set to Small, the Large option cannot be selected.
8 Use the Down [ ] button to select “Surr Back Ch,” and use
ENTER
the Left and Right [ ]/[
] but- tons to select 2ch or 1ch.
2ch: Select if two (left and right) surround back speakers are connected.
1ch: Select if one surround back
ENTER
speaker is connected.
Note:
• If the Surround and Surr Back set- tings in steps 6 and 7 are set to None, this setting does not appear.
9Press the [SETUP] button.
Speaker configuration is complete.
33