Advanced
4 |
| Use the Left and Right [ | ]/[ ] |
|
| buttons to adjust the speaker | |
| ENTER | level, and use the Down [ | ] but- |
|
| ||
ton to select the next speaker.
The levels can be adjusted from
ENTER
5Repeat step 4 so that the level of the test tone coming from each speaker is the same.
Speakers that you set to No or None in the Speaker Configuration (page 32) do not output the test tone.
6Press the [SETUP] button.
Setup closes.
Don’t forget to turn down the volume if you turned it up while setting the levels.
Notes:
•A quick way to adjust the speaker levels is to press the remote controller’s [TEST TONE] button to turn on the test tone. Use the
•If the multichannel DVD input is selected (page 35), in step 2, “3. MultiLevel” appears instead of “3. Level Cal,” and you can adjust the level of each channel of the multichannel DVD input. These level settings are independent of the Speaker Configuration settings on page 32.
Digital Signal Formats
The following table shows the display indicator for each digital signal format.
Format | Display | |||
|
|
|
|
|
Dolby Digital |
|
|
|
|
|
|
|
| |
|
|
|
|
|
DTS |
|
|
|
|
|
|
|
| |
|
|
|
|
|
PCM |
| PCM | ||
|
|
|
|
|
Normally, the AV receiver detects the signal format auto- matically. However, if you experience either of the fol- lowing issues when playing PCM or DTS material, you can specify the signal format as either PCM or DTS:
•If the beginnings of tracks from a PCM source are cut off, try the PCM setting.
•If noise is produced when fast forwarding or reversing a DTS CD, try the DTS setting.
|
|
|
|
|
|
| TUNING | / PRESET | MASTER VOLUME |
STANDBY/ON |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ENTER |
| |
| STANDBY |
|
|
|
|
|
|
|
|
A SPEAKERS B | TONE | + | STEREO | LISTENING MODE | DISPLAY DIGITAL INPUT | DIMMER MEMORY TUNING MODE | RETURN | SETUP |
|
|
|
|
|
|
| CLEAR |
|
|
|
|
|
|
|
|
|
|
|
|
| VIDEO 3 INPUT |
|
PHONES |
|
|
|
|
|
|
| VIDEO | L AUDIO | R |
MULTl CH | DVD | VIDEO 1 | VIDEO 2 | VIDEO 3 | TAPE | TUNER | CD | |||
|
| VCR |
|
|
|
|
|
|
|
|
DIGITAL INPUT
1Press and hold the AV receiver’s [DIGITAL INPUT] button for about 3 seconds.
2While “Auto” is displayed (about 3 sec- onds), press the [DIGITAL INPUT] button repeatedly to select: PCM, DTS, or Auto.
PCM: The PCM indicator flashes, and only input signals in PCM format will be output.
DTS: The DTS indicator flashes, and only input signals in DTS format will be output.
Auto (default): The format is detected automati- cally. If no digital input signal is present, the cor- responding analog input is used instead.
53
