Onkyo TX-SR803, TX-SR8370 First Time Setup, Press Enter, Disconnect the speaker setup, Microphone

TX-SR803_En.book Page 41 Friday, August 26, 2005 9:26 AM

First Time Setup—Continued

3

ENTER

Press [ENTER].

The automatic speaker setup starts. The test tone is output by each speaker in turn. The microphone picks up the sound and feeds it back to the AV receiver, where it’s used to calculate the optimum speaker settings. The whole process takes about 2 minutes.

Auto Speaker Setup

========================

Do not unplug Setup Mic.

Please, keep quiet.

Now measuring

Left

5	Disconnect the speaker setup
	microphone.
		Auto Speaker Setup
		=======================
		Please,unplug Setup Mic.

Tip:

•You can cancel the automatic speaker setup at anytime by disconnecting the microphone.

Note:

•If any extraneous noise is picked up by the microphone, the automatic setup may not work correctly, so keep quiet.

4

ENTER

ENTER

On completion, the following menu appears.

Auto Speaker Setup

========================

Apply the Results

Check the Results

Retry

Retry with

Test noise Level up

Cancel

Use the Up and Down []/[ ] buttons to select one of the fol- lowing options, and then press [ENTER].

☞Apply the Results:

Select this to save the results, then con- tinue with step 5. Normally, you’d select this option.

Check the Results:

Select this if you want to view the results. See “Checking the Results” on page 42.

Retry:

Select this if you want to run the auto- matic speaker setup again, starting from step 3.

Retry with Test noise Level up:

Select this to run the automatic speaker setup again but with the test tone louder, starting from step 3.

Cancel:

Select this to cancel the automatic speaker setup without saving the results, then continue with step 5.

41