TESTING THE
CONNECTIONS
Turn on your vehicle’s ignition and install your stereo’s faceplate (see “Installing the Faceplate” on Page 13). The stereo’s display lights and the last station you tuned ap- pears after about 5 seconds.
If the stereo does not work, immedi- ately disconnect the cable from your vehicle’s negative
terminal. Then recheck your con- nections.
After you verify that the display lights and the clock appears, follow the in- structions in “Mounting the Stereo.”
MOUNTING THE
STEREO
Be sure you verify that the stereo is connected properly (see “Testing the Connections” on Page 10). Then fol- low these steps to mount the stereo.
1.Make sure the ignition is turned off, then disconnect the cable from your vehicle’s negative (– ) battery terminal.
10
2.Disconnect the wire harness and the antenna.
3.Press REL (release) on the left side of the faceplate to remove the faceplate, then snap the plastic collar off of the front of the stereo.
Plastic Collar 
REL 
4.Insert both of the supplied keys into the slots at the middle left and right sides of the sleeve until they lock into place, and slide the sleeve off of the stereo.
