VCR SETUP
SETTING THE VCR’S OUTPUT CHANNEL SWITCH
If you connected the VCR’s VHF/UHF OUT TO TV terminal to a TV or another VCR, set 3 CH. 4 on the back of the VCR to 3 or 4, whichever is not an active channel in your area.
When VCR appears, the VCR sends the signal from the video source connected to its IN FROM ANT. jack or
Note: Setting 3 CH. 4 has no effect on the TV when the VCR is off or if you connected a TV with separate audio/video input jacks to the VCR’s
REMOTE CONTROL
Installing Batteries
The remote control requires two AA batteries (not supplied). For the longest operation and best performance, we recommend alkaline bat- teries (such as RadioShack Cat. No.
Cautions:
2.Put fresh batteries in the compartment, as indicated by the polarity symbols (+ and
3. Replace the cover.
Note: When the remote control stops working or operates poorly, replace both batteries.
Cautions:
•Never leave dead or weak batteries in the remote control. Batteries can leak chemi- cals that can damage your remote control.
•Dispose of dead batteries promptly and properly; do not bury or burn them.
Using the Remote Control
•Use only fresh batteries of the required size and recommended type.
•Do not mix old and new batteries, different types of batteries (standard, alkaline, or rechargeable), or rechargeable batteries of different capacities.
1.Press the tab on the battery compartment cover and lift off the cover in the direction of the arrow.
To use the remote control, aim it at the front of the VCR and press the desired function but- tons.
Tab
14
