Installation
When Power mode (Standby) is set to Eco, the VGA and RJ45 will be deacti- vated when the projector is in standby.
Powering the projector On / Off
Powering On the Projector
1.Remove the projector cap. 1
2.Securely connect the power cord and signal cable. Power on the switch 2 and the Power LED flashes Red.
3.Turn on the lamp by pressing “
” button either on the rear of the projector or on the remote. The POWER LED will now turn Blue. 3
The startup screen will display in approximately 10 seconds. The first time you use the projector, you will be asked to select the preferred language and power saving mode.
4.Turn on and connect the source that you want to display on the screen (computer, notebook, video player, etc). The projector will detect the source automatically. If not, push menu button and go to “OPTION”.
Make sure that the “Source Lock” has been set to “Off”.
If you connect multiple sources at the same time, press the “SOURCE” button on the control panel or direct source keys on the remote control to switch between inputs.
Turn on the projector first and then select the signal sources.
3
Or
1
| SOURCE |
| LENS | |
|
| SHIFT | ||
INFO. | MENU |
| ENTER | FOCUS |
AV MUTE |
|
|
| ZOOM |
VIDEO | Y | Pb | Pr | |
R | G | B | H | V |
12V OUT |
| RS232 |
|
|
2
English 14
