Appendices
The screws on the lamp cover and the lamp cannot be removed.
The projector cannot be turned on if the lamp cover has not been placed back on the projector.
Do not touch the glass area of the lamp. Hand oil can cause the lamp to shatter. Use a dry cloth to clean the lamp module if it was accidentally touched.
2 
1
4 
3
Lamp1 
Lamp2
5
Lamp Replacement Procedure:
1.Switch off the power to the projector by pressing the “
” button.
2.Allow the projector to cool down for at least 30 minutes.
3.Disconnect the power cord.
4.Unscrew the two screws on the lamp door. 1
5.Slide the lamp door sideways, then hook it round the bottom of the projector.
2
6.Unscrew the four screws on the lamp cover. 3
7.Unscrew the two screws on the lamp housing. 4
8.Lift up the lamp handle and remove the lamp module slowly and carefully. 5 To replace the lamp module, reverse the previous steps.
9.Turn on the projector and use “Lamp Reset” after the lamp module is replaced.
Lamp Reset: (i) Press “Menu” (ii) Select “OPTION” (iii) Select
“Lamp Settings” (iv) Select “Lamp 1 Reset” or “Lamp 2
Reset” (v) Select “Yes”.
English 58
