Orbit Manufacturing 94922 Programming Your Timer, Determine a Watering Plan, Set Start Times

•Press the ENTER button. The display now reads “SET MONTH.” Set the current month by pressing either the or button.

•Press the ENTER button. The display now reads “SET DATE.” Set the current day of the month by pressing either

the or button.

•Exit the set time and date mode at any time by turning the selection dial.

Determine a Watering Plan

See page 20 for instructions.

Section 3: Programming Your Timer

GD

NO

II

RR

EE

TP A / WY

A

O

D

N

Figure 2: Program A and Program B Dial Settings

Set Start Times

IMPORTANT: Multiple start times in Program A will repeat the water- ing program. Generally, only one cycle start time is required for each program (A and B) Start times do not correspond to individual stations.

07WTM002598 57926-24 rA.indd 6

•Turn the selection dial to START TIMES for the program you wish to set (A or B).

•Set Start Time 1 using the and buttons.

•If you wish to set additional start times (up to six) for the same

program, press the NEXT button or ENTER button.

• To remove a start time press CLEAR C .

•Exit the set start time mode by turning the selection dial.

Set Station Watering Durations

•Turn the selection dial to DURATION for the program you wish to set (A or B).

•Set the desired duration (0 - 120 minutes) for the station

displayed. Press NEXT or ENTER to advance to

the next station. Press CLEAR C to remove a duration.

IMPORTANT: Each station can have two durations. For example: Station 1 can have a duration of 5 minutes in Program A and a duration of 25 minutes in Program B. Typically a station has only one duration in either Program A of B. A station with a setting of 0 minutes will not water with that Program.

•If two programs are needed repeat these steps for the other program.

•Exit the set watering durations mode by turning the selection dial.

2/16/07 2:07:20 PM