Orbit Manufacturing p 801 295 9820, 91916, 57916, 57912 Using the Remote Control Device, English

Models: 91912 91926 94922 f 801 951 5815 57922 57926 57912 p 801 295 9820 57916 91916

1 40
Download 40 pages 20.36 Kb
Page 12
Image 12
Section 4: Using the Remote

the current station to the next station in the cycle. This can be done during scheduled, manual, or remote actuated watering.

Section 4: Using the Remote

Control Device

NOTE: The timer will accept commands from the remote control device only when the selection dial is turned to AUTO or OFF. (If the selection dial is turned to any other setting, commands from the Remote Control Device will be stored in memory and executed when the selection dial is turned to AUTO).

Install a Battery in the Remote Control Device:

Open the battery compartment door.

Install a 9-volt battery in the battery compartment.

Replace the battery compartment door.

To Synchronize the Remote Control Device with the Timer:

The remote device provided with your timer is already synchro- nized to your timer. If the remote is not functioning properly or if you are adding a new remote or RF sensor to your system do the following:

With the remote device in your hand press the “RF Sync” button on the timer (this will activate a red light on

the timer).

07WTM002598 57926-24 rA.indd 11

Press the OFF button on the remote or depress the stem of

ENGLISH

 

 

the RF sensor (the red light should start blinking).

 

If the red light blinks you have successfully synchronized the

 

 

devices. If the light does not blink check that the remote has a

 

 

fresh 9V battery or that the RF sensor switch is not OFF and

 

 

try the steps again.

 

To Water All Stations:

Press and release the ALL button on the remote control device to select all stations for watering.

Press and release the ON “X” MIN button to command the timer to water all the stations sequentially for the desired (“X”) number of minutes.

If you wish to advance to the next station before a station's watering duration is complete, press NEXT.

To Water One Station:

Press the number of the station you wish to water.

Press ON "X" MIN to water the station for the desired ("X") number of minutes.

To Water More Than One Specific Station:

Press the numbers of the stations you wish to water. (Example: 3, 7, 10, and 6. The timer will water in sequence from lowest to the highest. 3, 6, 7, 10.) (No matter which order you press the keys, the timer will water them sequentially from the lowest to the highest number.)

11

2/16/07 2:07:22 PM

Page 12
Image 12
Orbit Manufacturing p 801 295 9820, 91916 Using the Remote Control Device, Install a Battery in the Remote Control Device