![Activating the Batteries](/images/new-backgrounds/95089/9508911x1.webp)
Activating the Batteries
•Slide the docking port off the timer unit to gain access to the battery compartment door.
•Slide the door off the battery compartment in the direction of the arrow.
•Remove the black strip from the battery compartment.
•Replace the battery compartment door.
•Slide the docking port back onto the main controller unit.
The display will show “LOW BATTERY” when it is time to replace the batteries.
NOTE: Batteries alone will not operate the valves in your sprinkling system. The transformer must be plugged in and have power to oper- ate your system normally.
Reset the Timer
If this is the first time the sprinkler timer has been pro- grammed, you should press the small recessed button labeled RESET (located under the RAIN DELAY button). You will prob- ably need a pen, pencil or similarly small object to push it.
Do not press the RESET button again unless you want to com- pletely remove all your programming, including time and date.
07WTM002598
If no programming occurs after the RESET button has been | ENGLISH |
| |
pressed and the dial is left in the AUTO position the timer will |
|
assume a default program mode. In default mode, the timer will |
|
automatically water each station for 10 minutes, beginning at 5 |
|
a.m. each day. |
|
Select the Preferred Language
•Turn the selection dial to BUDGETING/LANGUAGE.
•Press the RAIN DELAY button.
• Press the NEXT button until the desired language is shown in the display.
•Exit the language selection mode by turning the selection dial or pressing the RAIN DELAY button.
Set the Time of Day and Date
If this is the first time the timer has been programmed, press the small recessed RESET button.
•Turn the selection dial to TIME/DATE.
•The top line of the display reads “SET TIME.” Set the current
time by pressing either the or
button.
NOTE: To move faster through the time or other selections, hold the
or
buttons down, rather than merely pressing and releasing.
• Press the ENTER button. The display now reads “SET YEAR.” Set the current year by pressing either the
or
button.
2/16/07 2:07:19 PM