Low Power Mode
When enabled, Low Power Mode causes the scanner to powerdown completely between trigger pulls. This results in very low idle current, lowering the energy needs of the scanner. It does, however, require the scanner's microcontroller to reboot with every trigger pull. This will introduce a very small delay in scanning when this mode is enabled. Therefore, it is recommended that this mode only be used when the scanner is connected to a battery powered terminal.
| The state of this feature is not affected by the |
| RETURN TO FACTORY DEFAULTS program- |
| ming bar code. It must be manually enabled |
NOTE | or disabled using the programming bar codes |
below. |
Scan these labels to enable and set the Low Power Mode.
SET
Enable Step #1
Enable Step #2
Disable Step #1
Disable Step #2
END
Programming Guide | 139 |