Setting Label

I.D. bySymbology

To set symbology-specific label identifiers (Label I.D.):

1.Look at the ASCII chart on the inside back cover, and identify the ASCII character(s) and the corresponding Hex Code(s) for the ASCII characters you will use as identifiers.

For example: You need to change the Label I.D. for UPC-A to ‘A1’.

2.Scan the SET bar code on page 58.

3.Scan the bar code starting on page 58 representing the symbol- ogy whose Label I.D. you wish to modify. Scan only one sym- bology type per programming session.

In our example, we would scan the ‘UPC-A’ symbology bar code.

4.Identify and scan the four digits from the Appendix C: Keypad on page 147 that correspond to the Hex Values you determined in step one above. Return to this page and go to step five.

The hex values from the ASCII chart that correspond to ‘A1’ from our example are as follows: 41 hex = ‘A’, and 31 hex = ‘1’. Thus, we would scan digit programming bar codes in this order: 4, 1, 3, 1.

5.Scan the END bar code on page 60.

Successful programming requires 4 digits for the Label I.D.

NOTE

You have changed the default Label I.D. for UPC-A from ‘A’ to ‘A1’.

Programming Guide

57