Handshaking controls are mutually exclusive. The settings below allow only one of these features to be enabled at a time, as enabling multiple controls will produce unpredictable results.
| Each of the handshaking features requires | |
| that a series of bar codes (Step #1, Step #2) in | |
| the sequence given. That is, you must enter | |
| Programming Mode by scanning the SET bar | |
| code, scan the bar codes required to set one | |
NOTE | handshaking feature, then scan the END bar | |
code. | ||
|
Scan the SET bar code label then the Step #1, Step #2 below, followed by the END bar code labels to enable CTS/RTS Flow Control.
Enable CTS/RTS Flow Control
SET
Step #1---------
Step #2---------
END
Programming Guide | 25 |