Oregon Handheld Laser Scanner 33

Software Handshaking

Xon/Xoff - is software handshaking that allows the host to control data transmission. If the host sends an Xoff command to the scanner, the scanner will not send the bar code data until it receives an Xon command from the host. If the host sends the Xoff command during data transmission, the host will receive additional characters for no more than 2ms1.

Scan the SET bar code label then the Step #1, Step #2 below, followed by the END bar code labels to enable Xon/Xoff Control.

Enable Xon/Xoff Control

SET -------------------------------------------

Step #1---------

Step #2---------

END ------------------------------------------

1. Timing varies slightly depending upon the baud rate selected.

Programming Guide