Oricom TP68 Connect Mains Power Supply, Connecting the telephone cable, Fitting the desk support

Models: TP68

1 29
Download 29 pages 22.37 Kb
Page 8
Image 8

- Setting up -

3.5Connect Mains Power Supply

In order to enjoy maximum performance and convenience, you must use the mains power supply provided. The batteries should always be installed, even when using the mains power supply, to protect against power cuts. Connect the main power supply to the power socket and the jack marked DC 9V on the underside of the telephone.

Note: In the event of power cut the batteries will maintain full operation for a few days.

3.6Connecting the telephone cable

Connect the telephone cable supplied to the telephone wall socket and to the socket

marked with a symbol on the base of the phone. Then feed the cable out of the telephone housing either upwards or downwards through the cable guide. Clip the cable firmly in the cable channel.

3.7Fitting the desk support

If you intend to use your telephone on a desk, then the desk support supplied must be fitted. To do this, turn the telephone over. Now insert the two upper hooks into the openings provided and push the desk support firmly home.

If you ever need to remove the support, press gently on the middle clips on the upper edge and then pull the desk support off.

In the handset rest there is a small hanging device, which is used when the telephone is wall mounted. This hanging device is not required when the telephone is used on a desk, as it impedes lifting of the handset. Using a small screwdriver, turn this hanging device until the screw is completely flush and its upper end does not protrude at all.

3.8Wall mounting

Your telephone is also suitable for wall mounting. Use two screws for fixing. Drill two holes horizontally side by side, 70mm apart, and leave the screws protruding from the wall by 5mm. Now place the telephone over the screws and push it slightly downwards.

There is a small hanging device in the handset rest to prevent the handset from falling when it is placed on the rest with the telephone mounted on the wall. Using a small screwdriver, turn this hanging device until a small hook appears at the upper end.

If you are using the telephone fitted to the wall, you can hang the handset on the telephone without hanging up. You will find a small hook for this purpose at the upper end of the handset rest.

8

Page 8
Image 8
Oricom TP68 manual Connect Mains Power Supply, Connecting the telephone cable, Fitting the desk support, Wall mounting