- Setting up -
3.9Modem Connection
The telephone has a “MODEM” socket for connection of a modem or fax machine on the right side of the unit. Please note that this connection uses the same telephone line as the telephone itself. The connected device cannot be used at the same time as the telephone.
3.10Recall setup
You can use the Recall button on your telephone when using your network operator’s services such as call waiting etc. A subscription may apply for these services, contact your network operator more information. If this is not working correctly check the setting of the Recall timing inside the Settings Menu. Refer to chapter 6 for viewing and changing the Recall setting. In Australia it should be set at 100ms and for New Zealand it should be set at 600ms for use on a normal telephone line.
3.11Setting the Time / Date
If you want to reset the current time and date or change a value already entered, proceed as follows:
Note: All entries must be made as two digits. If you want to enter the date 8th of October, press the numbers 08 for the day and 10 for the month.
PLEASE FOLLOW THE INSTRUCTIONS:
Press the MENU button.
Turn the Jog dial until the “Settings” message appears in the display.
Now press the YES button twice.
Now enter the current day, the month, the hour and the minutes one after the other using the keypad.
The date and time are saved by pressing the YES button.
To exit programming mode, press the NO button twice.
Display shows:
Add entry
Settings
Date and time. The first figure of the date flashes.
If you want to set the 24th October and the time 15.05, enter the numbers “24 10 15 05” using the keypad.
9
