10.Specifications of the StarBlast 6/6i
Primary mirror diameter: | 150mm |
Primary mirror: | Parabolic |
Secondary mirror |
|
minor axis: | 47.0mm |
Focal length: | 750mm |
Focal Ratio: | f/5.0 |
Mirror Coatings: | Aluminum with SiO2 overcoat |
Focuser: | |
| eyepieces |
Eyepieces: | 25mm and 10mm Sirius Plössl, |
| 1.25" |
Magnification: | 30x (with 25mm eyepiece), 75x |
| (with 10mm eyepiece) |
Finder: | EZ Finder II reflex sight |
Weight: | 23 lbs., 8 oz. |
Tube Length: | 28 inches |
11.Specifications of the IntelliScope System
Objects in database:
•110 Messier (M) objects
•7840 New General Catalog (NGC) objects
•5386 Index Catalog (IC) objects
•8 Major planets
•99
Computer interface: | |
Power: | Requires one 9V battery |
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes of modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a resi- dential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interfer- ence to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or televi- sion reception, which can be determined by turning the equip- ment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an output on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
•A shielded cable must be used when connecting a peripheral to the serial ports.
27
