1Hex key (size 4mm)
3 Plastic feet
3 Feet attachment wood screws (length 1")
5 Encoder board mounting wood screws
1Brass bushing
1Azimuth axis
2 Fender washers (diameter 1")
1Hex lock nut
4Altitude bearing cylinders
4Altitude bearing cylinder screws (length 1.5", black)
1Vertical stop knob
3Flat washers (2x1/16" thick, 1x1/32" thick)
Box #3: Primary Mirror and Cell
Qty Description
1Primary mirror
1Mirror cell
3Collimation knobs
3Nylon washers
3Springs
2. Assembly
Now that you have unpacked the boxes and familiarized yourself with all the parts in front of you, it’s time to begin assembly.
Assembly of the Optical Tube
In order to prevent damage to the primary mirror in ship- ment, it is shipped in its cell separately from the optical tube. To install the mirror cell into the optical tube, the rear end ring attached to the optical tube must first be removed. This is done by unthreading and removing the six
Figure 2. To remove the rear end ring, unthread the six screws that connect it to the tube.
Warning: Once the rear end ring is removed from the tube, the raw edge of the tube itself will be exposed. Be careful not to cut or otherwise hurt yourself on the tube’s edge. Also be careful not to pinch yourself when attach- ing the assembled mirror cell onto the tube.
Next, assemble the rear end ring to the mirror cell. Find a clean, flat surface, and turn the mirror cell over so that the mirror is facing downwards. Place the three springs onto the three exposed threaded shafts (Figure 3). Lower the end ring onto the mirror cell so the threaded shafts pass through it, and the end ring rests on the springs (Figure 4). Add a nylon washer to each collimation knob and thread the collimation knobs through the end ring and onto the threaded shafts (Figure 5). Make sure the knobs have at least three full turns of engagement on the shafts. The mirror cell is now ready to be installed into the tube.
Figure 3. Place the three springs on the exposed threaded shafts of the mirror cell.
Figure 4. Lower the rear end ring onto the mirror cell so that the threaded shafts pass through the end ring, and the end ring rests on the springs.
4
