HP Pro QV985AV manual Removal and Replacement Procedures Microtower MT Chassis

6Removal and Replacement Procedures Microtower (MT) Chassis

Adherence to the procedures and precautions described in this chapter is essential for proper service. After completing all necessary removal and replacement procedures, run the Diagnostics utility to verify that all components operate properly.

NOTE: Not all features listed in this guide are available on all computers.

Preparation for Disassembly

See Routine Care, SATA Drive Guidelines, and Disassembly Preparation on page 45 for initial safety procedures.

1.Remove/disengage any security devices that prohibit opening the computer.

2.Close any open software applications.

3.Exit the operating system.

4.Remove any diskette, compact disc, or media card from the computer.

5.Turn off the computer and any peripheral devices that are connected to it.

CAUTION: Turn off the computer before disconnecting any cables.

Regardless of the power-on state, voltage is always present on the system board as long as the system is plugged into an active AC outlet. In some systems the cooling fan is on even when the computer is in the “Standby,” or “Suspend” modes. The power cord should always be disconnected before servicing a unit.

6.Disconnect the power cord from the electrical outlet and then from the computer.

7.Disconnect all peripheral device cables from the computer.

8.As applicable, lay the computer down on its side to achieve a safe working position.

NOTE: During disassembly, label each cable as you remove it, noting its position and routing. Keep all screws with the units removed.

CAUTION: The screws used in the computer are of different thread sizes and lengths; using the wrong screw in an application may damage the unit.

54 Chapter 6 Removal and Replacement Procedures Microtower (MT) Chassis