WIRING CONFIGURATIONS
The MaxxBass® Processor is recommended in two different configurations.
1. Front Stereo Configuration
The figure below illustrates the wiring for a front stereo configuration. One MaxxBass® Processor is used between the front channel source and front speaker amplifier to increase the bass response only on the front speakers.
Implementing MaxxBass® on the front speakers will increase the perceived bass response of these speakers down to 30-40Hz providing a Virtual Subwoofer. The listener will achieve better bass balance and imaging with a rear mounted subwoofer or trunk mounted speakers with sufficient bass response.
CD Receiver
Front speakers
LF with Virtual RF SubwooferTM
Front Rear
Maxx
Bass®
Power
Amplifiers
LRRR
Subwoofer
8
