Orion Car Audio XTREME 600.4 owner manual Boost Levels 0dB +3dB +6dB +10dB Enclosure Type

INTELLI Q

Setting up and using INTELLi Q

1.The first step to using the INTELLi Q is to install the amplifier. Seriously, basic installation techniques for new XTREME and HCCA “Type R” amplifiers remain unchanged. Set the low-pass crossover as you would in “normal” installations. (Normal Orion of course.)

2.Determine which type of enclosure you are using. Refer to the table below for tuning assistance. For example: for vented enclosures, set the high-pass crossover to the tuning frequency (port frequency) of the enclosure. If you have a woofer such as the new HCCA woofers up to 10dB of boost can be used. For woofers of lesser excursion capability, it is recommended to use up to 6dB of boost only.

3.For RTA tuning, start the INTELLi Q boost setting at 0dB. Using pink noise, slowly increase the Q adjustment until the desired frequency response is achieved. In situations where you are require more boost than is recommended, you can lower the crossover frequency to get a similar desired effect.

4.For tuning by ear, start the INTELLi Q boost setting at 0dB. Using music the high-energy low frequency content, slowly increase the Q adjustment until the desired sonic performance in achieved. In situations where you are require more boost than is recommended, you can lower the crossover frequency to get a similar desired effect

Boost Levels	0dB	+3dB	+6dB	+10dB
Enclosure Type :	Acceptable No Problems	High X-Max Drivers Tune	Not Recommended	Not Recommended
Infinite Baffle	Tune above Fs of woofer	above Fs of woofer
Sealed	Acceptable No Problems	Acceptable No Problems	High X-Max Drivers Tune	Not Recommended
	Tune above Fs of woofer	Tune above Fs of woofer	above Fs of woofer
Vented	Acceptable No Problems	Acceptable No Problems	Acceptable No Problems	High X-Max Drivers Tune to
	Tune to port frequency	Tune to port frequency	Tune to port frequency	port frequency
Sealed Bandpass	Acceptable No Problems	Acceptable No Problems	High X-Max Drivers Tune	Not Recommended
	Tune above Fs of woofer	Tune above Fs of woofer	above Fs of woofer
Vented Bandpass	Acceptable No Problems	Acceptable No Problems	Acceptable No Problems	High X-Max Drivers Tune to
	Tune to port frequency	Tune to port frequency	Tune to port frequency	port frequency
Aperiodic	Set crossover to Fs of woofer	Set crossover to Fs of woofer	Set crossover to Fs of woofer	Not Recommended

page 30